Tips for using and storing the freezer properly, saving electricity

Please check the power supply first before use
- Before using the freezer, you must check the power of the freezer as stated in the user manual, usually the voltage of the freezer is: 220V/50~60H. So you must check the power before plugging in the device.
- In addition, to minimize the dangers of electricity, do not plug many devices into the same power outlet. Use a separate power outlet for the device.
- The minimum power cord to use the freezer must be loaded with at least 6A.
- After plugging in the power, put the temperature control button at number 4, then the red and green lights will come on, if there is a snow film inside the cabinet, it proves that the machine is working well.
- When you turn off the power or unplug the cabinet, it must wait at least 5 minutes before it can be turned on again.

Store food in the freezer properly

-First, you should see the instructions written on the outside of the freezer to put the food in the right place and at the right temperature.
- The distance of foods in the refrigerator must be reasonable, do not put food close together inside the refrigerator, this helps to keep the cold temperature in the refrigerator necessary.
- Do not put water bottles and cans in the freezer when the temperature is below 0 degrees
- For food, when freezing, the amount of water in the food will be lost, so we should use wrap or sealed containers to store food when putting it in the freezer. This also helps you limit the smell of food remaining in the refrigerator
- Should not contain flammable substances, volatile substances, strong alkalis, strong acids, kerosene...
- With the freezer to make yogurt and smoothies, you should equip plastic baskets to help the cold air convection into the cabinet, helping the food to freeze faster.
Store the freezer properly
Regularly clean to ensure the cabinet is always clean:
- With the freezer, you have to defrost once a week.
- Do not tilt the refrigerator more than 40 degrees, as this will damage the compressor.
- Clean the refrigerator and radiator at least once a month to prolong the life and keep the freezer clean.
- Do not use a knife or sharp object to pry the snow out, this will puncture the wall of the cabinet and cause damage.
- It is recommended to defrost the refrigerator when the snow covers the inside of the cabinet from 5mm or more,
Install the freezer in a suitable location
- During installation, you should not tilt the cabinet more than 45 degrees to reduce damage caused by moving. Do not cut power immediately after moving.
- Place the cabinet at least 15cm from the wall and 30cm from the surrounding.
- Place the cabinet in a cool and dry place, place it on a flat surface and avoid direct sunlight.
- Place the cabinet away from water baths, places with high heat sources such as stoves and volatiles.